ESAB POWERCUT-1250 Manual de Instruções Página 1

PT-32EHPLASMA ARC CUTTING TORCHES0558003746Instruction Manual (GB)

66SECTION 2 DESCRIPTION

67SECTION 3 INSTALLATION3.1 FITTING THE PT-32EH TORCH1. For operator safety, the torch connections arelocated on the output terminal board behind the

683.2 GENERALMake sure power switch on console is in the "OFF"position and primary input power is deenergized.3.3 ASSEMBLYInstall PT-32EH

694.1 STEEL HEAT SHIELD GUARDS(Refer to Figure 4-1)ADJUST GUIDE BY TURNING IN ACLOCKWISE DIRECTION ONLY. THISWILL PREVENT ACCIDENTAL LOOS-ENING OF SHI

70SECTION 4 OPERATION4.2 CUTTING WITH THE PT-32EHUse the following procedures to cut with the PT-32EH torch (Figure 4-4).1. Make sure that the wall

2115.1 GENERALBefore any maintenance is attempted on this torch,make sure the power switch on the console is in the"OFF" position and the pr

2125.3 REMOVING / REPLACING TORCH HEADAND SWITCHES FROM SERVICE LINE5. Next, remove the Pilot Arc connection from theTorch Head using two wrenches to

213Replacement parts may be ordered from your ESABdistributor or from:ESAB Welding & Cutting ProductsAttn.: Customer Service Dept.PO Box 100545, E

214NotesNotesNotesNotesNotes

215Revision HistoryRevision HistoryRevision HistoryRevision HistoryRevision HistoryOriginal Release on February 13, 200305/2003 - revised fuse part nu

These INSTRUCTIONS are for experienced operators. If you are not fully familiar with the principlesof operation and safe practices for arc welding an

0558003746 05 / 2003ESAB ABSE--695 81 LAXÅSWEDENPhone +46 584 81 000Fax +46 584 123 08www.esab.comESAB subsidiaries and representative officesEuropeAU

TABLE OF CONTENTSSECTION TITLE PAGEPARAGRAPHSECTION 1 SAFETY...

TABLE OF CONTENTSii

61Full responsibility for safety of personnel working on or near system rests on user of ESAB WeldingEquipment.Wrong operation can lead to abnormal si

62! WARNING !ARC WELDING AND CUTTING CAN BE INJURIOUS TO YOURSELF AND OTHERS. TAKEPRECAUTIONS WHEN WELDING OR CUTTING. ASK YOUR EMPLOYER FOR SAFETY PR

63SECTION 2 DESCRIPTIONPT-32EH TorchDesigned for superior cutting performance and ease ofhandling, the PT-32EH produces clean, exceptionallyhigh qua

64SECTION 2 DESCRIPTIONOptional Accessories:50/70 amp Spare Parts Kit (PC-875/1125) ...055800282270 amp Spare Parts Kit (PC-1500) ...

652.1 GENERALThe patent pending PT-32EH is a manual torch with a90° head designed for use with several Plasma ArcCutting Packages using clean, dry a