ESAB MultiPower 460 Pulse Manual de Instruções descarregar pdf (Página 18)

2. WIRE FEEDER CONTROL RECEPTACLE

This 19-pin receptacle (J1) accepts the control cable from the wire feeder

and handles all the control signals needed to operate a 42 Vac wire feeder.

3. REMOTE CONTROL RECEPTACLE

This receptacle (J2) is provided for an optional 14-pin control cable from the

optional remote pendant, Tig torch control or foot control . This receptacle

is operative only if the PANEL/REMOTE switch on the power source front

panel is in the REMOTE position.

4. CONTACTOR "ON/OFF" SWITCH

This switch provides manual control of the welding contactor when the

PROCESS switch on the control panel is in the MIG position (CV welding).

An example of when to use this switch is when CV carbon arc gouging is

needed or an "Off the Arc" wire feeder with secondary contactor is operated

in the CV mode.

5. AUXILIARY 115 VAC RECEPTACLE

A 115 Vac receptacle is provided to supply power to accessories such as a

water cooler, heated CO

regulator, or small hand tools. The receptacle is

rated 115 Vac / 10 amps with a floating neutral.

6. 42VAC AND 115 VAC CIRCUIT BREAKER (CB1 & CB2)

These resetable 10 amp circuit breakers (CB1 & CB2) protect the 42 volt wire

feeder/control and 115 volt auxiliary receptacle circuitry against over current.

(Table 6-1 provides troubleshooting information).

SECTION 2 DESCRIPTION

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Sem comentários

ESAB MultiPower 460 Pulse Manual de Instruções Página 18