ESAB MultiPower 460 Pulse Manual de Instruções descarregar pdf (Página 13)

Figure 2-3. Control Panel

SECTION 2 DESCRIPTION

C. CONTROL PANEL DESCRIPTION

(Refer to Figures 2-3 and 2-4)

1. FAULT LAMP

The RED fault light on the MultiPower 460 front panel indicates a prob-

lem with set-up parameters.

2. TEMPERATURE LAMP

The TEMP lamp illuminates if an over temperature condition occurs within the

MultiPower 460 power source. This condition may be caused by excessive

duty cycle or over-current conditions. When an over temperature condition

occurs, the welding output is turned off and the unit must be allowed to cool.

The machine will automatically reset when the temperature falls to a safe

level.

3. PROCESS SELECTOR SWITCH

The three position process selector switch is located in the upper right-hand

corner of the control panel. The process selector switch position provides the

visual indication of which weld process (Mig, Tig or stick) has been selected.

4. DIGITAL DISPLAY/METERS (WFS, AMPS & VOLTS)

The digital displays located on the left side of the control panel are

multifunctional depending on the welding process being used. The top

display reads wire feed speed in inches per minute in the MIG PRESET mode

and welding current (amps) in the TIG and STICK PRESET mode. During

welding both displays indicate average welding current and average welding

voltage.

Fault

Lamp

WFS - IPM

Lamp

Amps

Lamp

Digital Meter

Amps/WFS

Power “ON”

Lamp

Temperature

Lamp

Digital Meter

Volts

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Sem comentários

ESAB MultiPower 460 Pulse Manual de Instruções Página 13