ESAB MultiPower 460 Pulse Manual de Instruções descarregar pdf (Página 14)

DESCRIPTION

SECTION 2

When using a DuraDrive 4-30 or DuraDrive 4-48 Wire Feeder, the wire feed

speed is displayed in inches per minute (IPM) in the top display when the

PRESET button is pressed and the wire speed adjustment knob on the wire

feeder is rotated. The WFS LED beside the top display meter will light when

the display is showing wire feed speed.

5. VOLTAGE / CURRENT / TRIM

The arc voltage is controlled with this knob when the WELD PROCESS

selector switch is in the MIG position. The Mig arc voltage can be preset

by pressing the PRESET button and reading the arc volts in the bottom

digital display while rotating this knob.

The arc current is controlled with this knob when the WELD PROCESS

SWITCH is in the TIG or STICK position. The welding current can be preset

in amperes by pressing the PRESET button and reading the current (amps)

in the top digital display while rotating this knob. The average weld current

will be displayed during welding.

6. PANEL/REMOTE SWITCH

With this switch in the PANEL position, output voltage in the CV mode and

the output current in the CC mode are controlled by adjusting the VOLTAGE/

CURRENT/TRIM knob on the power source control panel to the desired

output. In the REMOTE position, output is controlled using a remote control

device such as a wire feeder, hand control or foot control.

NOTE:

A DuraDrive Wire Feeder is required to

preset wire feed speed.

Weld Process

Switch

Preset

Button

Current

Voltage

Panel/

Remote

Inductance

Figure 2-4. Control Panel

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Sem comentários

ESAB MultiPower 460 Pulse Manual de Instruções Página 14