ESAB MultiPower 460 Pulse Manual de Instruções descarregar pdf (Página 26)

NOTE

"OFF THE ARC" Wire Feeders can use

either MIG (CV) or STICK (CC) Process

Selection. Place the contactor toggle

switch on the accesssory panel (see

Figure 2-5) to the "ON" position.

SECTION 4 OPERATION

return to zero. There is no “HOLD” circuit for the display meters when using the

TIG and STICK process modes.

E. MIG WELDING PRESET PROCEDURE

When the PROCESS switch is placed in the MIG position, the MultiPower 460

is set for CV (constant voltage) welding. The power source will output open

circuit voltage (OCV) when the Mig Gun trigger is depressed. The following

procedure assumes the wire feed and voltage adjustments will be made from

the wire feeder front panel and wire and gas have been installed.

Step 1. Connect wire feeder to MultiPower 460 and set PANEL/REMOTE

switch to REMOTE position.

Step 2. Place the WELD PROCESS switch in the MIG (center) position.

Step 3. Press and release the PRESET button then turn the wire speed

control on the wire feeder to the desired speed shown on the top

digital display window of the MultiPower 460.

Step 4. Turn the VOLTAGE knob on the wire feeder to the desired arc

voltage in the bottom digital display window of the

MultiPower 460.

Step 5. Set the shielding gas flow rate to 35 cfh by activating the gas purge

switch on the wire feeder or pulling the gun trigger and turning the

adjustment knob on the Flowmeter.

Step 6. Connect the work cable to the part to be welded and pull the gun

trigger to start welding. Trim the wire speed and volts as needed for

the desired arc characteristics and weld quality.

Step 1

Step 2

Step 3

Figure 4-1 Standard Mig Setup Procedure

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Sem comentários

ESAB MultiPower 460 Pulse Manual de Instruções Página 26