ESAB MultiPower 460 Pulse Manual de Instruções descarregar pdf (Página 14)

DESCRIPTION

SECTION 2

When using a DuraDrive 4-30 or DuraDrive 4-48 Wire Feeder, the wire feed

speed is displayed in inches per minute (IPM) in the top display when the

PRESET button is pressed and the wire speed adjustment knob on the wire

feeder is rotated. The WFS LED beside the top display meter will light when

the display is showing wire feed speed.

5. VOLTAGE / CURRENT / TRIM

The arc voltage is controlled with this knob when the WELD PROCESS

selector switch is in the MIG position. The Mig arc voltage can be preset

by pressing the PRESET button and reading the arc volts in the bottom

digital display while rotating this knob.

The arc current is controlled with this knob when the WELD PROCESS

SWITCH is in the TIG or STICK position. The welding current can be preset

in amperes by pressing the PRESET button and reading the current (amps)

in the top digital display while rotating this knob. The average weld current

will be displayed during welding.

For MIG PULSE welding, the arc length (arc voltage) is controlled with this

knob. The WELD PROCESS switch is placed in the MIG position and the

mode switch is placed in the PULSE position. The knob should be place at

the 12 o'clock position as the synergic preset for the wire feed speed, WIRE

TYPE and WIRE DIAMETER choosen by the operator using the PULSE

SELECTION switches. The arc length can then be adjusted by turning the

knob clockwise to increase the arc length or counterclockwise to decrease

the arc.

6. PANEL/REMOTE SWITCH

With this switch in the PANEL position, output voltage in the CV mode and

the output current in the CC mode are controlled by adjusting the VOLTAGE/

CURRENT/TRIM knob on the power source control panel to the desired

output. In the REMOTE position, output is controlled using a remote control

device such as a wire feeder, hand control or foot control.

Figure 2-4. Pulse Control Panel

Panel/

Remote

Wire Diameter

Selector (Pulse)

Inductance

Weld Process

Switch

Material Selection

(Pulse)

Mode

Switch

Preset

Button

Current

Voltage

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Comentários a estes Manuais

Sem comentários

ESAB MultiPower 460 Pulse Manual de Instruções Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Sistema de solda ESAB MultiPower 460 Pulse