ESAB MultiPower 460 Pulse Manual de Instruções descarregar pdf (Página 16)

DESCRIPTION

SECTION 2

1. POWER ON/OFF SWITCH & LAMP

The main power switch is located on the right front panel of the power source.

This switch energizes the main transformer, control circuitry and illuminates

the Power “ON” lamp.

2. WIRE FEEDER CONTROL RECEPTACLE (OPTIONAL)

PN - 0558003003

This 19-pin receptacle (J1) accepts the control cable from the wire feeder

and handles all the control signals needed to operate a 42 Vac wire feeder.

3. REMOTE CONTROL RECEPTACLE

This receptacle (J2) is provided for an optional 14-pin control cable from

the optional remote pendant, Tig torch control or foot control . This

receptacle is operative only if the PANEL/REMOTE switch on the power

source front panel is in the "REMOTE" position.

4. CONTACTOR "ON/OFF" SWITCH

This switch provides manual control of the welding contactor when the

PROCESS switch on the control panel is in the MIG position (CV welding).

An example of when to use this switch is when CV carbon arc gouging is

needed or an "Off the Arc" wire feeder with secondary contactor is

operated in the CV mode.

5. AUXILIARY 115 VAC RECEPTACLE

A 115 Vac receptacle is provided to supply power to accessories such as

a water cooler, heated CO

regulator, or small hand tools. The receptacle

is rated 115 Vac / 10 amps with a floating neutral.

6. 42VAC (CB-2) AND 115 VAC CIRCUIT BREAKER (CB-1)

These resetable 10 amp circuit breakers (CB-1 & CB-2) protect the 42 volt

wire feeder/control and 115 volt auxiliary receptacle circuitry against over

current. (Table 7-1 provides troubleshooting information).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Sem comentários

ESAB MultiPower 460 Pulse Manual de Instruções Página 16