ESAB MultiPower 460 Pulse Manual de Instruções descarregar pdf (Página 34)

SECTION 4

OPERATION

Jumper Plug Removed and Harness connected (as factory shipped)

Non-Synergic Mode - The pulse parameters are determined by the position of

the pulse selection switches, the MultiPower 460 Pulse TRIM knob and Wire

Feed Speed preset.

Figure 4-7 Jumper Plug Removed and Harness Connected

Jumper Plug Installed

Synergic Mode - Pulse circuitry is looking for a 1 volt per 100 inches per

minute signal to determine the pulse parameters requied to make the weld.

Figure 4-8 Jumper Plug Installed (Factory Shipped)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

Sem comentários

ESAB MultiPower 460 Pulse Manual de Instruções Página 34