ESAB MultiPower 460 Pulse Manual de Instruções descarregar pdf (Página 33)

Figure 4-2 Standard Stick Setup Procedure

Be sure to set the polarity to DCEP (Electrode Positive) by placing the Electrode Holder cable in the Positive con-

nection lug on the front of the power source.

Place the WELD PROCESS switch in the STICK position.

Place the PANEL/REMOTE switch in the PANEL position.

Place STANDARD/MIG PULSE switch in the STANDARD position.

While holding the PRESET button, turn the VOLTAGE/CURRENT knob to the desired weld current displayed in the

top digital display window for the stick electrode type and size being used .

Strike the electrode on the workpiece and start welding. Trim the welding current as needed for the desired

weld pool control.

D. Stick Welding

When the PROCESS switch is placed in the STICK position, the MultiPower 460 Pulse establishes open circuit voltage (OCV)

and output power is immediately available for welding. This means that the STICK electrode holder is “HOT”, and an arc will

strike when the electrode comes in contact with the workpiece.

Arc Force is automatically enabled when the WELD PROCESS switch is set to the STICK position. The level of Arc Force is

automatically adjusted by the current preset being used. Due to the "Built-In" Arc Force in the stick mode, the actual current

may be greater than the preset value.

When the WELD PROCESS switch is moved to the TIG or STICK position,

electrode becomes electrically “HOT”. Do not allow the electrode to

contact ground potential until you are ready to make a weld.

CAUTION

SECTION 4 OPERATION

.045

.040

.035

1/16

.052

WIRE TYPE

WIRE DIAMETER

PULSE SELECTION

EN-625 ERNiCrMo-3

STAINLESS

AL-4000

AL-5000

EN-60 ERNiCu-7

METAL CORE

STEEL

EN-67 ERCuNi

Voltage (CV)

Current (CC)

Trim (Pulse)

TEMP

POWER

BLINKING

WIRE SPEED

OUT OF RANGE

STEADY

NO PROGRAM

PRESET

MIG

LIFT

START

TIG

STICK

REMOTE

PANEL

STANDARD

MIG PULSE

Auto Fan

Fan will cycle automatically

Multipower 460PULSE

WFS-IPM

AMPS

VOLTS

NOTE

When using the MP-460 Pulse with an Optional Remote Pendent Control , the STANDARD/MIG PULSE

switch must be in the STANDARD position for proportional current control. Set the current knob on

the MP-460 Pulse front panel to the maximum desired weld current level. The remote device will then

control the current proportionally between the minimum current setting of 5 amps and the maximum

current set on the MP-460 Pulse front panel. The maximum Stick welding current is 525 amps.

If the MP-460 PANEL/REMOTE switch is left in the REMOTE position while using a Remote Pendant Con-

trol option, the current range will be full scale or 10 to 400 amps on the remote device. Adjustment of the

maximum current on the MP-460 Pulse front panel is defeated.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 68 69

Comentários a estes Manuais

Sem comentários

ESAB MultiPower 460 Pulse Manual de Instruções Página 33

Comentários a estes Manuais

Manuais e produtos relacionados com Sistema de solda ESAB MultiPower 460 Pulse