ESAB MultiPower 460 Pulse Manual de Instruções descarregar pdf (Página 36)

.045

.040

.035

1/16

.052

WIRE TYPE

WIRE DIAMETER

PULSE SELECTION

EN-625 ERNiCrMo-3

STAINLESS

AL-4000

AL-5000

EN-60 ERNiCu-7

METAL CORE

STEEL

EN-67 ERCuNi

Voltage (CV)

Current (CC)

Trim (Pulse)

TEMP

POWER

BLINKING

WIRE SPEED

OUT OF RANGE

STEADY

NO PROGRAM

PRESET

MIG

LIFT

START

TIG

STICK

REMOTE

PANEL

STANDARD

MIG PULSE

Auto Fan

Fan will cycle automatically

Multipower 460PULSE

WFS-IPM

AMPS

VOLTS

SECTION 4 OPERATION

NOTE

When using the MP-460 Remote Pendant Con-

trol, place the PANEL/REMOTE switch in the

REMOTE position. This will defeat the MP-460

front panel voltage control. Voltage can then

be adjusted from the remote pendant

Figure 4-6

Contactor Switch for "Oﬀ the

Arc" wire feeders

Figure 4-7 Synergic Pulse MIG Setup

G. Pulse Mig Setup

Connect wire feeder to MultiPower 460 Pulse and set PANEL/REMOTE switch to PANEL position.

Set the STANDARD/MIG PULSE switch to the MIG PULSE position.

Place the WELD PROCESS switch in the MIG (center) position.

Set the PULSE SELECTION switches to the WIRE TYPE and DIAMETER installed on the wire feeder.

Press and release the PRESET button then turn the TRIM knob to the approximate welding wire feed speed

needed for the wire type and size to be used. If the MIG CONTACTOR is in the “ON” position the PRESET button

must be held down to preset the wire feed speed.

Flip the CONTACTOR switch on the MP-460 auxiliary panel to the “ON” position. See Fig. 4-6.

Turn the wire speed knob on the wire feeder to the desired wire feed speed.

Connect the work cable from the MP-460 and the voltage pick-up lead from the wire feeder to the part to be

welded.

Activate the gas purge switch if the wire feeder has this feature. If not, release the pressure roll so wire does not

feed. Pull the gun trigger and set the shielding gas ﬂow rate by turning the adjustment knob on the shield gas

ﬂowmeter to the recommended gas ﬂow (typically 35 cfh).

Engage the drive stand pressure roll and begin welding by pulling the gun trigger. Trim the arc length using the

wire speed control knob on the wire feeder. Adjust the heat content of the arc by increasing or decreasing the

Trim knob on the MP-460 Pulse front panel.

10.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 68 69

Comentários a estes Manuais

Sem comentários

ESAB MultiPower 460 Pulse Manual de Instruções Página 36

Comentários a estes Manuais

Manuais e produtos relacionados com Sistema de solda ESAB MultiPower 460 Pulse